|
|
|
 |
September 08, 2010 |
 |
 |
 |
 Dust Control:
Because of its amazing wetting ability, Safe-N-Clean is useful in areas where dust is a problem. Where grading, access roads, and construction areas create dust problems. Safe-N-Clean can be very effective in helping to control dust by reducing water consumption, watering equipment, and labor.
Add 5 gallons of Safe-N-Clean to 3,000 gallons of water in watering trucks or sprinkling system. Spray dust control areas as necessary to keep area damp and dust down. Hyper-wetting agents in Safe-N-Clean will cause the water to penetrate thoroughly, while the colloids in effect attract the dust particles holding them together to form loam. Continuous application in an area will give a good base after 6 to 10 times depending on soil and dust conditions. Once a base is established, the ratio can be reduced to 1 gallon Safe-N-Clean to 3,000 gallons water; the frequency of application will be reduced and the total water volume will be decreased from one half to two thirds the quantity needed without Safe-N-Clean.
The combined action of colloids and wetting agents suggests the use of Safe-N-Clean in areas where dust particles in the air create a potentially explosive environment. Use at a concentration of 1 part Safe-N-Clean to 100 parts water and atomize into the air. |
| There are many more applications for Safe-N-Clean Industrial Cleaner Degreaser. When in doubt, try a test spot. On smooth surfaces, spray on and wipe off is usually sufficient. On grained or rough surfaces or where exceptionally difficult stains or soils are encountered, some agitation with an appropriate brush may be required. Where applicable, always wash from the bottom up and rinse from the top down. This will prevent streaking. |
|
|
 |
 |
Info © 2003 SAFE-N-CLEAN • 2281 Graystone Drive • St. Charles, MO 63303 • info@safenclean.com
Toll-Free: 800.253.7426 • Phone: 636.925.3821 • Toll Free Fax: 800.635.9398 • Fax: 636.925.3865
Design ©2010 / Maintenance provided by jWeb New Media Design |
 |
|
